AZP, datasheet for AZP – LOW POWER QUAD OPERATIONAL AMPLIFIERS provided by BCD Semiconductor Manufacturing Limited. AZP pdf. AZP-E1 from BCD Semiconductor Manufacturing Limited. Find the PDF Datasheet, Specifications and Distributor Information. The AZ consists of four independent, high gain and internally frequency compensated Detailed information please refer to the relevant datasheet. Package.
|Published (Last):||8 January 2007|
|PDF File Size:||5.61 Mb|
|ePub File Size:||5.97 Mb|
|Price:||Free* [*Free Regsitration Required]|
Exposure to “Absolute Maximum Ratings” for extended periods may affect device reliability. In addition to this diode action, there datwsheet also lateral NPN parasitic transistor action on the IC chip.
AZP Datasheet(PDF) – BCD Semiconductor Manufacturing Limited
It is specifically designed to operate from a single power supply. Destructive dissipation can result from simultaneous shorts on all amplifiers. The input common-mode voltage of either input signal voltage should not be allowed to go negatively by more than 0.
This current is essentially constant, independent of the state of the output so no loading change exists on the input lines. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under “Recommended Operation Ratings” is not implied.
This typically can be detected as this type of capacitance increases at higher frequencies. Current Limiting Issue Date: Advanced Analog Circuits does not assume any responsibility for use of any circuitry described other than the circuitry embodied in Advanced Analog Circuits’ products.
Stresses greater than those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. dataasheet
Short circuits from the output to VCC can cause excessive heating and eventual destruction. This input current will only exist when the voltage at any of the input leads is driven negative. This is not destructive and normal output states will re-establish when the input voltage, which was negative, again returns to a value greater than Operation from split power supply is also possible and the low power supply current drain is independent of the magnitude of the power supply voltages.
Power Amplifier 7 Rev. Input Voltage Range Figure 5.
This transistor action can cause the output voltages of the op amps to go to the VCC voltage level or to ground for a large overdrive for the time duration that an input is driven negative.
Voltage Follower Pulse Response 5 Rev.
The upper end of the common-mode voltage range is VCC – 1. When considering short circuits to ground, the maximum output current is approximately 40mA independent of the magnitude of VCC. The company makes no representation that circuitry described herein is free from patent infringement or other rights of Advanced Analog Circuits Corporation. Pulse Generator Issue Date: Output Characteristics Current Sourcing Figure It is due to the collector-base junction of the input PNP transistors becoming forward biased and thereby acting as input diode clamps.
Fixed Current Sources R1 Figure Due to proximity of external components, insure that coupling is not originating via stray capacitors between these external parts.