DAC/DAC 8-Bit µP Compatible, Double-Buffered D to A Converters. General Description. The DAC is an advanced CMOS/Si-Cr 8-bit multiplying . As the name itself points out ‘DAC’ is a DAC chip or Digital to Analog Conversion IC. The device is from DAC series that are 8-bit. DAC/DAC 8-Bit μP Compatible, Double-Buffered D to A Converter Data LM Operational Amplifier Data Sheet, National Semiconductor Corp.
|Published (Last):||18 September 2009|
|PDF File Size:||14.74 Mb|
|ePub File Size:||17.17 Mb|
|Price:||Free* [*Free Regsitration Required]|
This op-amp circuit is called current-to-voltage converter.
Pin Configuration DAC is a twenty pin device and description for each pin is given below. The device is specifically designed for it to be interfaced directly with the,Z80, and other datashfet microprocessors.
We can use the circuit to develop applications without worry as the circuit is tested working. For working da0c832 device DAC we have connected a voltage source of 15V as shown in diagram.
8-bit Microprocessor Compatible, Double-Buffered D/A Converter
The analog voltage output from the op-amp circuit is in direct relation with inputted digital value and hence DAC conversion with DAC is achieved. Now for understanding the working let us consider the example datqsheet circuit given in the datasheet.
TL — Programmable Reference Voltage.
So to convert the current parameter in to voltage parameter we will use op-amp circuit as shown in circuit diagram. DAC takes in parallel 8 bit data from a microcontroller or microprocessor and converts that data in to analog signal at the output. The chip is designed with CMOS technology to achieve low power datashee and low output leakage current errors.
The device is available in the market for low cost and can be easily worked with. The design also includes special circuitry that provides TTL logic input voltage level compatibility.
All these control pins need to be setup appropriately as mentioned above for successful DAC conversion of the device. DAC also designed with silicon-chromium R-2R resistor ladder network which divides the reference current and provides the circuit with excellent temperature tracking characteristics 0.
National Semiconductor – datasheet pdf
DAC IC basically used in applications where an 8 bit digital data needed to be converted to analog value. This also permits the simultaneous updating of any number of DACs. This analog signal is the current cac0832 that is directly proportional to the input digital value and this current parameter datazheet to be converted in to voltage parameter for further use.
Submitted by admin on 21 November So the device is used for converting 8 bit parallel digital data input to analog signal output. Double buffering of the device allows outputting a voltage corresponding to one digital word while holding the next digital word.